The Work Network Attributes  command provides a subfile of  all network
attributes and  their current values.  A Change  option exists to allow
a  prompt for CHGNETA and  the specifically selected network attribute.
The  existing current  value  is  shown  during the  prompt.    WRKNETA
provides  a  significantly better  interface  than  the system  CHGNETA
command which prompts for all parameters and shows *SAME.

The command has no parameters and would be entered as:

              WRKNETA

If  you are not authorized to CHGNETA,  the Change option is not valid.

WRKNETA escape messages you can monitor for
--------------------------------------------

None.  Escape messages from based on functions will be re-sent.

Command parameters                                    *CMD
------------------

   OUTPUT        How to  output  the results.    *  is the  default  to
                 display the network attributes and allow changes.

                 If  the  command is  entered  in  batch or  *PRINT  is
                 specified,  the spooled  file is output  using DSPNETA
                 OUTPUT(*PRINT).

Restrictions
------------

You must be authorized to CHGNETA to enable the Change option.

Prerequisites
-------------

The following TAA Tools must be on your system:

     DSPERRMSG       Display error message
     EDTNETA         Edit network attribute
     EDTVAR          Edit variable
     SNDESCMSG       Send escape message

Implementation
--------------

None, the tool is ready to use.

Objects used by the tool
------------------------

   Object        Type    Attribute      Src member    Src file
   ------        ----    ---------      ----------    ----------

   WRKNETA       *CMD                   TAANETE       QATTCMD
   TAANETEC      *PGM       CLP         TAANETEC      QATTCL
   TAANETEC2     *PGM       CLP         TAANETEC2     QATTCL
   TAANETER      *PGM       RPG         TAANETER      QATTRPG
   TAANETED      *FILE      DSPF        TAANETED      QATTDDS