The No Op command does  not perform any operation.  Its  function is to
allow  a   command  to  be  specified  when  one   is  required  for  a
specification,  but  no  run time  function  is needed.    A completion
message is sent if the command is run.

The command has no parameters and would be entered as:

             NOOP

NOOP escape messages you can monitor for
----------------------------------------

None.

Restrictions
------------

None.

Prerequisites
-------------

The following TAA Tools must be on your system:

     SNDCOMPMSG      Send completion message

Implementation
--------------

None, the tool is ready to use.

Objects used by the tool
------------------------

   Object        Type    Attribute      Src member    Src file
   ------        ----    ---------      ----------    ----------

   NOOP          *CMD                   TAACMEH       QATTCMD
   TAACMEHC      *PGM       CLP         TAACMEHC      QATTCL