The Display Outfile Format  command displays the fields in  a format of
the model  file for commands  that create outfiles.   Many DSP commands
and  CVT commands  support an  outfile.   Both system and  TAA commands
are supported.   If multiple  outfiles exist for  the command (such  as
DSPFD),  the   DSPOUTFILE  command  is  used  to   allow  a  selection.
DSPOUTFMT may only be used interactively.

A typical command would be:

             DSPOUTFMT  CMD(DSPOBJD)

The format for the model file (QADSPOBJ) would be displayed.

DSPOUTFMT escape messages you can monitor for
---------------------------------------------

      TAA9891    The command is not known to have an outfile

Escape messages from based on functions will be re-sent.

DSPOUTFMT Command parameters                          *CMD
----------------------------

   CMD           The  command which creates  an outfile.  It  must be a
                 system or TAA command that supports an outfile.


Restrictions
------------

  **   DSPOUTFMT may only be used in an interactive environment.

  **   Only system and TAA commands are supported.

Prerequisites
-------------

The following TAA Tools must be on your system:

     DSPFMT          Display format
     DSPOUTFILE      Display outfile
     RTVOUTFILE      Retrieve outfile format
     SNDESCINF       Send escape information
     SNDESCMSG       Send escape message

Implementation
--------------

None, the tool is ready to use.

Objects used by the tool
------------------------

   Object        Type    Attribute      Src member    Src file
   ------        ----    ---------      ----------    ----------

   DSPOUTFMT     *CMD                   TAADBNG       QATTCMD
   TAADBNGC      *PGM       CLP         TAADBNGC      QATTCL