The  Display  Completion  Codes command  displays  the  job  completion
codes  described  in  the  CPF1164  message.   This  provides  a  quick
review.

A typical command would be:

             DSPCOMPCDE

A listing would be displayed of the completion codes.

DSPCOMPCDE escape messages you can monitor for
----------------------------------------------

None.  Escape messages from based on functions will be re-sent.

DSPCOMPCDE Command parameters                         *CMD
-----------------------------

   OUTPUT        How  to  output  the results.    * is  the  default to
                 display the  spooled file  if the  command is  entered
                 interactively.   The spooled file is  deleted after it
                 is displayed.

                 If  the  command  is entered  in  batch  or  *PRINT is
                 specified, the spooled  file is  output and  retained.


Restrictions
------------

None.

Prerequisites
-------------

The following TAA Tools must be on your system:

     RTVSYSVAL3      Retrieve system value 3
     SNDCOMPMSG      Send completion message
     SNDESCINF       Send escape information
     SNDESCMSG       Send escape message

Implementation
--------------

None, the tool is ready to use.

Objects used by the tool
------------------------

   Object        Type    Attribute      Src member    Src file
   ------        ----    ---------      ----------    ----------

   DSPCOMPCDE    *CMD                   TAAMSJN       QATTCMD
   TAAMSJNC      *PGM       CLP         TAAMSJNC      QATTCL
   TAAMSJNR      *PGM       RPG         TAAMSJNR      QATTRPG