The Work Current User command is similar to the WRKUSRJOB system
command except that the current user of the job is also shown. This
allows support for jobs that swap profiles to be displayed and
operated on. The same options as on WRKUSRJOB such as CHGJOB are
supported. Only active jobs are displayed.
See the DSPCURUSR command for a similar function that supports
'display only' options.
When entering the command, the 'job user' name (the user profile
assigned when the job started) must be described (the default is the
current user profile). You may optionally describe a 'current user'.
You must have *JOBCTL special authority to request a 'job user' name
other than your own.
A typical command would be:
WRKCURUSR JOBUSER(QUSER) CURUSER(*ALL)
All jobs that were started with the QUSER profile regardless of the
current user name that are active would be displayed. The same
options as appear on WRKUSRJOB may be entered to perform actions on
the job.
The F16 key acts as a toggle switch between displaying the job user
or the subsystem name.
WRKCURUSR escape messages you can monitor for
---------------------------------------------
TAA9895 No jobs exist for the specified user
Escape messages from based on functions will be re-sent.
Command parameters *CMD
------------------
JOBUSER Enter the name of the 'job user' that you want to
display jobs for. The 'job user' is the user
profile name that the job was started with. The
default is * meaning the current user profile.
A specific user or *ALL may be entered. Using *ALL
causes slower performance as all active jobs must be
considered.
You must have *JOBCTL special authority to request a
'job user' other than your own or *ALL users.
CURUSER Enter the name of the 'current user' that you want
to display jobs for. The 'current user' is the user
profile name that the job is currently running
under. The default is *ALL meaning any current user
profile.
A specific user may be entered.
JOBTYP The type of job to provide information for. The
default is *BOTH for both batch and interactive.
*INTERACT may be entered to access only interactive
jobs.
*BATCH may be entered to access only batch jobs.
OUTPUT How to output the results. * is the default to
present an interactive display if the command is
entered interactively.
If the command is entered in batch or *PRINT is
specified, a spooled file is output.
Restrictions
------------
You must have *JOBCTL special authority to request a user other than
your own.
Prerequisites
-------------
The following TAA Tools must be on your system:
CHKJOBCTL Check job control special authority
FILEFDBCK File feedback
RPGSTSDS RPG status data structure
SNDESCINF Send escape information
SNDESCMSG Send escape message
TAAEXC TAA Execute
Implementation
--------------
None, the tool is ready to use.
Objects used by the tool
------------------------
Object Type Attribute Src member Src file
------ ---- --------- ---------- ----------
WRKCURUSR *CMD TAAJODL QATTCMD
TAAJODLC *PGM CLP TAAJODLC QATTCL
TAAJODLC2 *PGM CLP TAAJODLC2 QATTCL
TAAJODLR *PGM RPG TAAJODLR QATTRPG
TAAJODLD *FILE DSPF TAAJODLD QATTDDS
|
