TAA Tools
DSPTOOLCMD      DISPLAY TOOL COMMANDS                  TAATOLP

The Display  Tool Commands  tool allows  the entry  of a  tool name  to
present a display of the commands that make up the tool.

A typical command would be entered as:

           DSPTOOLCMD   TOOL(MSGCTL)

A subfile  display would be shown  with one entry for  any command that
is part of the tool.

Options exists to:

  **   Prompt for the command

  **   Display the source information about the command

The F6 function key may be used to display the tool documentation.

If  the tool does not have any  commands, the display appears with only
F6 valid to be used.

If the  tool name given  is not  a tool  but a command  name, the  tool
name is  determined and  the display  appears as if  the tool  name had
been entered.  For example, if the command is entered as:

           DSPTOOLCMD   TOOL(STRMSGCTL)

the  name given is not a tool,  but it is a TAA  command name.  In this
case  the tool  name  (MSGCTL)  is  determined  and  the  same  display
appears as if the command had been entered as TOOL(MSGCTL).

Command parameters                                    *CMD
------------------

   TOOL          The tool  or command  name.   Only TAA  Tools and  TAA
                 command names may be used.

Restrictions
------------

None.

Prerequisites
-------------

Not a consideration as only the object form exists on your system.

Implementation
--------------

None, the tool is ready to use.

Object only tool
----------------

DSPTOOLCMD is  shipped in object form only.   The source does not exist
on your system.
					

Added to TAA Productivity tools May 1, 1996


Home Page Up to Top