CHGCMDLIB CHANGE COMMAND LIBRARY TAATOMK
The Change Command Library command allows you to change the name of the alternate library used for TAA commands (and a few other TAA objects). Depending on the existing command library and the new command library, you may be asked to run DLTTAACMD and/or DUPTAACMD. You must have *ALLOBJ special authority to use CHGCMDLIB. A prompt override command exists. Just enter: CHGCMDLIB The existing command library name will appear in the command prompt to allow a review. Change the name as required. Depending on the existing command library and the new command library, you may be asked to run DLTTAACMD and/or DUPTAACMD. All TAA commands exist in library TAATOOL. You may have an additional library where the commands (and a few other TAA objects) exist. See the discussion with the HELPTAA menu option for 'Library list requirements'. CHGCMDLIB escape messages you can monitor for --------------------------------------------- None. Escape messages from based on functions will be re-sent. Command parameters *CMD ------------------ CMDLIB The name of the new command library. All TAA commands exist in library TAATOOL. You may have an additional library where the commands (and a few other TAA objects) exist. See the discussion with the HELPTAA menu option for 'Library list requirements'. Restrictions ------------ None. Prerequisites ------------- The following TAA Tools must be on your system: CHKALLOBJ Check *ALLOBJ special authority RTVTAALIC Retrieve TAA license SNDCOMPMSG Send completion message SNDESCINF Send escape information SNDESCMSG Send escape message Implementation -------------- None, the tool is ready to use. Objects used by the tool ------------------------ Object Type Attribute Src member Src file ------ ---- --------- ---------- ---------- CHGCMDLIB *CMD TAATOMK QATTCMD TAATOMKC *PGM CLP TAATOMKC QATTCL TAATOMKC2 *PGM CLP TAATOMKC2 QATTCL TAATOMKC2 is the prompt override program.